Showing posts with label Remote Control. Show all posts
Showing posts with label Remote Control. Show all posts
Monday, September 12, 2011
Remote Control Circuit using NE555 & LM567
Remote control circuit consists of two parts, one is the transmitter and the other is the receiver. A simple schematic diagram of the remote control. IC transmitter transmitter circuit is controlled by NE555. Receiver circuit works by the frequency of the signal, which is emitted by the transmitter circuit. Transmission frequency of the signal must be equal to the decoder frequency receiver circuit. The frequency generated NE 555 is the same as the receive frequency of the IC LM 567.
Resistor R1 is a variable receiver to facilitate the adjustment process. The system works well when the circuit is ready. The first step is the optimization through the transmitter is turned on continuously, while the receiver R1 to set the value of being able to detect the signal from the transmitter. The second part is the receiver is controlled by LM 567. The following is a schematic drawing receptor.
In the image at the top of each channel is designed with a different frequency. Given the bandwidth of the frequency detection signal LM 567, between the frequencies on which they owe a big enough difference, let's try with a difference of 5 KHz.
[read here...]
Resistor R1 is a variable receiver to facilitate the adjustment process. The system works well when the circuit is ready. The first step is the optimization through the transmitter is turned on continuously, while the receiver R1 to set the value of being able to detect the signal from the transmitter. The second part is the receiver is controlled by LM 567. The following is a schematic drawing receptor.
In the image at the top of each channel is designed with a different frequency. Given the bandwidth of the frequency detection signal LM 567, between the frequencies on which they owe a big enough difference, let's try with a difference of 5 KHz.
Tuesday, June 28, 2011
115 Volt Infrared Remote Control
115 Volt Infrared Remote Control Circuit DiagramThis circuit will allow you to turn on any piece of equipment that operates on 115 volts ac. The receiver circuit is based on the Radio Shack infrared receiver module (MOD), part number 276-137. It is also available from some of the other sources listed on my Links page. The MOD accepts a 40khz IR signal that is modulated at 4 khz. When a signal is received the MOD will go low. The sensitivity of the MOD is set by different values for R1 and C1.
The values for R1 may need to be as high as 10,000 ohms and for C1 40uf. This will prevent the unit from turning on under normal lighting conditions. You will need to experiment with the values that work best for you. The output of the 4013 chip a flip flop toggles on and off with the reception of a IR pulse. The output of the 4013 turns on the MOC optical coupler which in turn switches on the triac and supplies power to the AC load.
The values for R1 may need to be as high as 10,000 ohms and for C1 40uf. This will prevent the unit from turning on under normal lighting conditions. You will need to experiment with the values that work best for you. The output of the 4013 chip a flip flop toggles on and off with the reception of a IR pulse. The output of the 4013 turns on the MOC optical coupler which in turn switches on the triac and supplies power to the AC load.
Subscribe to:
Posts (Atom)